For dry build up: A101/1200D

Water connection from the back or top via mounting holes	1/2 "
Functional range of water pressure	0,05 – 0,8 MPa
Recommended range of water pressure	0,3 – 0,5 MPa
Big flush	6 – 9 l
Small flush	2,5 – 3,5 l
Factory setting of large flush	6 l
Factory setting of small flush	3 l
Hygienic reserve	3 l
Water volume in the cistern	9 l
Load test	400 kg

For wall-hung WC
For easy transport in combined packaging
For mounting in front of a support wall or in to a plasterboard construction
For floor thickness 0–200 mm
For use in packaging of sets including ceramics
For installation of wall-hung WC pans with a connecting pitch of 180 mm or 230 mm

Allows for easier handling and transport
The frame allows the anchoring to a separate sufficiently strong plasterboard partition, in front of the bearing wall
The installed module is covered with a plasterboard panel and there is no need for any additional fixing or anchoring elements
The construction of polystyrene insulation prevents condensation forming on the surface of the tank and dampens the vibrations from the tank into the building structure
Prepared for connecting a bracket with a DG 1/2” conversion for bidet seats and sprays
Dual flush independently adjustable with hygienic reserve
Suitable for installation of remote or sensor flushing
Compatible with all ALCA flush plates
The cistern is made of one piece, thus ensuring 100% impermeability
Water supply from the rear/top
Maintenance work without using any tools
The service opening cover simplifies assembly and prevents the penetration of moisture and impurities
Installation depth adjustable from 20–95 mm
Mounting depth 125 mm, with waste elbow 160 mm
Adjustable telescopic feet, range 0–200 mm
Frame material: powder-coated metal

Cistern with fill and flush valve
Self-supporting frame – dividable into two parts
Fittings 1/2" water connection with the integrated angle valve Schell 1/2–3/8"
Flushing mechanism screw 2 pcs
Fixation set: screw Ø8×60 – 6 pcs, anchor Ø12 – 6 pcs
Fixation material for fixing the WC pan: threaded rod M12 – 2 pcs, washers – 4 pcs , cover – 2 pcs, nut – 2 pcs, thread protector – 2 pcs
Connecting frame spacers 2 pcs, screws 6 pcs
Elbow waste connector HT 90/110 polyethylene, PE-HD
Inlet seal, PP outlet, wrapping seal
Drainage seal, PP connector, connector seal
End-caps set for protecting the connecting holes during installation of the system
Service opening cover is simply adjustable, screws 4 pcs

M0017C-ND	Inlet fill valve bracket (range AM)
M0029-ND	Waste pipe holder
M0039-ND	Sleeve

A101/1200D