SPECIFICATIONS OF SHOWER DRAINS ALCA
Low installation height
Low installation height:
55 mm for drains with an outlet pipe diameter of 40 mm (suitable for renovations).
85 mm for drains with an outlet pipe diameter of 50 mm (suitable for new buildings).
Stainless Steel DIN 1.4301 (EN 17240).
Treatments of materials employed:
Pickling and passivation, electrochemical polishing.
Protection against dirt during installation:
The collar and trap are protected by foil, and the channel itself by a styrofoam insert.
Vysoký průtok vody
(až 68 l/min)
Maximum water fl ow rate:
68 l/min for drains with an outlet pipe diameter of 50 mm.
44 l/min for drains with an outlet pipe diameter of 40 mm.
Two traps in one: The high fl ow rate achieved by the double compartment trap system.
Standard: EN 1253
Completely cleanable trap
Construction: 2 outlet compartments, 2 removable inlet parts and 2 protective grid traps.
Cleanability: The protective grid trap will catch most of the dirt, but by removing it and the inlet part you can clean the drain all the way to the waste pipe!
Combined dry odour trap
Optional accessories for stainless steel shower drains with double compartment trap system
For areas such as recreation facilities, utility rooms and premises with seasonal use the associated possibility of drying out of the water trap can be eliminated by installation of a combined dry odour trap.
- Flow rate of 68 l/min
- Compatible with stainless steel linear drains APZ1, APZ4, APZ5, APZ6, APZ16, APZ1016, APZ11, APZ1001, APZ1011, APZ1004, APZ1006, ARZ1
- Set of 2 pieces for 1 linear shower drain
- Possible to replace the built-in linear shower drain
If there is no water fl ow through the waste, the fl aps remain closed and even when the water seal dries out they still prevent odours rising from the sewer.
In normal use the fl aps open and close to allow the water to drain out.
Complete package includes all accessories
Complete package includes all accessories:
- Shower drain pre-assembled with a trap
- Installation set (bolts, plugs)
- Waterproofi ng tape
- Protective foil covering for the collar and inlet pipe, and protective insert for drainage channel
Tailor made solutions available
Length range: 300–2,200 mm for a single section. Lengths greater than 2,200 mm can be achieved by connecting sections as required.
Height variants: Diff erent edge heights and depths of the drainage channel can be supplied on request.
Odour trap: Can be positioned wherever the customer wishes. Depending on the water fl ow, more than one trap can be used in a single drain.
Material:Standard stainless steel DIN 1.4301, EN 17240. For aggressive environments (swimming pools) stainless steel DIN 1.4404, EN 17349.
To maintain a perfect look, clean the system at least once a month. Do not use sharp objects or abrasives for cleaning as that can damage the surface of the grid.
- shower drain ALCA
- odour trap
- foundation slab
- concrete screed
- primer coat
- waterproofi ng tape
- waterproofi ng material
- fl exible fi ller
- installation legs
- grid ALCA