Specifications
Dispenser for WC cistern tablets included
Odour removal directly from the WC bowl
Can be connected to a extraction fan (not included)
Recommended fan flow rate 30 m³/h, a pressure of 60 Pa and a check valve, the fan must be positioned at least at a height of 1.2 m from the floor
Sliding rail holder for the waste connector can be set to eight positions between 0–93 mm
Angle valve with the ability to connect to the Mepla piping system
This technical solution allows anchoring to an uneven surface of the back wall where a cut out was made, in the range of 50 mm
Galvanized support structure with four hinged brackets for easy installation
The construction of the polystyrene insulation simplifies the process of walling-in, prevents condensation forming on the surface of the tank and dampens the vibrations from the tank into the building structure
Removable piece of polystyrene allows for easy access during installation
Prepared for connecting a bracket with a DG 1/2” conversion for bidet seats and sprays
Dual flush independently adjustable with hygienic reserve
Suitable for installation of remote or sensor flushing
Compatible with all ALCA flush plates
The cistern is made of one piece, thus ensuring 100% impermeability
Water supply from the rear/top
Maintenance work without using any tools
The service opening cover simplifies assembly and prevents the penetration of moisture and impurities
Installation depth adjustable from 20–95 mm
Installation depth 125 mm
Material of the load bearing structure: galvanized metal